Our latest BLITZ Mini Stack used in our iFlight BNFs. Ultra fast F7 MCU, powerful 55A for 2-6S batteries. 20×20 mounting pattern. The perfect match for your new frame. Improved circuit design, better components and lower electrical noise! DJI HD VTX Connector (Plug-and-Play / No soldering required), FC indicator LEDs for visual debugging.

 

Specifications:

MCU: STM32F745

Gyro: ICM42688

Barometer: DPS310

OSD Chip: AT7456E

Flash: 16MB (Blackbox flash)

UARTS: 6

Smartaudio / IRC Tramp VTX protocol supported

LED controller: Yes

Beeper pad: Yes

Mount pattern: 20*20mm/φ4

Dimensions: 30.5*27 mm

Weight: 4.8g

BEC: Output 5V 2.5A continuous output current, 3A peak current (15 seconds)

BF Firmware target: IFLIGHT_BLITZ_F7_AIO

Ardupilot Firmware：arduplane_with_bl

 

Wiring Suggestions:

UART 1 for VTX HD / Analog

UART 2 for a Receiver

UART 3/4/5 for GPS or other sensors that require a serial port

UART 6 for ESC Telemet

 

ESC Specifications:

Mounting Holes: 20*20mm/Φ4mm

Weight: 11.3g

Supports 2-6S lipo input

MCU: BB21

Constant: 55 Amps

Burst: 65 Amps

Telemetry Output: No

Current sensor: Yes

Current rate: 200

BEC: No

Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.

Target:   Q-H-25 16.7(BlheliS) / Bluejay Q-H-50 (Bluejay)

 

Packing List:

1 x BLITZ Mini F745 Flight Controller

1 x BLITZ Mini E55S 4-IN-1 2-6S ESC

1 x silicon grommets

1 x wire harness for F7 Flight controller

 

Wiring Diagram:

https://drive.google.com/drive/u/1/folders/17Uf67I6ER_z-otviR0I7tSqO31W7S553

 

Note:

Please use our GoogleDrive Database to download the Ardupilot firmware of the FC：

https://drive.google.com/drive/folders/1r3MNTBNYSzGeRXQg45j4IJVoW1Xjk7Y0