The Happymodel CrazyBee F4 Lite Flight Controller brings lots of power in a small package. This 4-in-1 FC comes with an integrated receiver (FrSky), ESC, and an onboard 5.8GHz VTX!
Notes
- R1(RX1) Pad is used for IBUS/DSM2/DSMX signal input
- IR1(IRX1) Pad is used for SBUS signal input (Already inverted)
- R1 and IR1 Cannot be used simultaneously
Specifications
FC
- (Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: MPU-6000(SPI connection)
- Board size: 28.5 * 28.5MM
- Power supply: 1S battery input (DC 2.9V-4.35V)
- Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
- Built-in Betaflight OSD(SPI Control)
- Built-in 5.8G VTX
- Built-in SPI Frsky/Flysky receiver
- Built-in 5V 1A BEC
- Built-in voltage detection
Onboard 4in1 ESC
- MCU upgraded to EFM8BB21
- Power supply: 1S LiPo/LiPo HV
- Current: 5A continuous peak 6A (3 seconds)
- Support BLHeliSuite programmable
- Factory firmware: O_H_5_REV16_7.HEX
- Default protocol: DSHOT600
Onboard Frsky SPI D8
- SPI BUS receiver Frsky D8 compatible
- Compatible Non-EU transmitter D8 model
- Channels: 8ch
- Failsafe support
- No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Onboard 5.8GHz VTX
- Output power: 25mw
- Frequency: 40CH
- Input voltage: 3.3V 5.5V
- Current consumption: 300mA(type)
- Frequency: 5.8GHz 5bands 40 channels
- With Race band
- Smart audio ready
Includes
- 1 x Happymodel CrazyBee F4 Lite 1S Whoop Flight Controller – Frsky
Reviews
There are no reviews yet.